But the best I've been able to do so far is to hunt-and-peck, just randomly searching through all the DipTrace cap components looking. I know that Digikey has a KiCad library that can be imported, but there's only a few thousand components in it.īack to my 4.7uF example in the OP, I'm sure there are many components for a capacitor within DipTrace that have a pattern suitable for my cap with 0.5mm dia leads spaced at 5mm. ![]() But how do I find a suitable match?Ĭlick to expand.I've certainly used filters, but haven't seen a DigiKey library within Diptrace. There is nothing particularly remarkable about this, and I'm sure there are many other parts with the exact same characteristics. It has a lead diameter of 0.5mm and a lead spacing of 5.0mm. Take, for example, a 4.7 uF through-hole ceramic capacitor from TDK. I'd be quite content to use a substitute symbol and pattern, but I don't know how to find one with exact hole sizing and spacing that matches my actual part. I know how to create a component from scratch in the component editor and pattern editor, but I don't want to have to do that for every piece in my project. With millions of components in the world out there, I'm not surprised that DipTrace's library doesn't have every one, but I am surprised that of all the parts I've looked for, it hasn't had a single one. But so far, not a single component I've looked for, from converters, resistors, inductors, to opamps, has shown up within the DipTrace library. ![]() I'm working on a schematic in DipTrace with the intent of creating a PCB, so the patterns associated with the component matters. I've searched a lot of threads and tutorials for this, but have so far not found anything helpful.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |